Straightening and cutting machine И6122A is used for straightening from round metal from coils and cutting it into bars of measured length.
The machine consists of a rotating correct frame, roller feed and lever cut. From the decoiler, the end of the wire is guided into the feed rollers of the front feed mechanism. Using the lever-eccentric clamping mechanism, the feed rollers are clamped, thereby supplying wire to the crackers of the correct frame. Straightening of the material is carried out in all planes by its multiple transverse plastic bending with the correct crackers installed in the nests of the fast-rotating regular frame. After straightening the material in the correct frame, the wire is fed through the wiring to the feed rollers of the rear feed mechanism. The rectified section of the wire through the cutting sleeve, fixedly mounted in the housing of the feed mechanism, is fed into the closed chute of the receiving tray until it stops, adjusted to the required length of the cut rod, after which it is cut off.