ИР 1330 press is used for bending sheet and strip metal.
Ppress lubrication system – combined. Overload fuses – pressure switch, force indicator, overload fuse. Operating modes – single stroke, continuous stroke, push, manual rotation.
Adjustable frequency of continuous strokes of the press slide: the highest – at least 40 per minute, the smallest – at least 10 per minute. The number of single inclusions provided by the brake clutch and the control system is at least 26 per minute.
The bed of the press consists of two racks connected by a table and two spacers. The left strut also serves as a platform for installing the drive and air distribution devices. Racks with a table are connected by keys with cylindrical mutually perpendicular surfaces. On sections of struts operating in tension, traction is welded between the walls, and a gear housing is located in the upper part of the right strut. Slider support guides are rectangular.
Press drive consists of a high-slip V-belt drive electric motor, a brake clutch mounted in a flywheel and gears located on the receiving shaft, two intermediate and eccentric shafts. Gear clutch located on an intermediate short shaft allows two slider speeds.
The front stop is a welded bracket that is mounted in the T-shaped groove of the table on the front side and leans through the screw into the table. Two front stops are installed on the ИР1330 press, so they can be used as a receiving table for small batches of workpieces.
Back stop is fixed in the T-slot of the table from the inside and is supported by two installation bolts in the table. Designed to abut the sheet when bending strips up to 700 mm wide. The combined use of the rear and front stops provides efficient bending of workpieces without reconfiguration.