Hydraulic guillotine НГ25Г.01 is designed for direct longitudinal and transverse cutting of sheet material. Metal cutting is performed in one stroke of the knife according to the marking or stop. Convenience in work, reduced levels of noise, high cutting quality and reliability of hydraulic guillotine shears, as well as various equipment options, allow to operate this equipment in industries with high demands on equipment quality. The shears work setting is controlled from the remote control, working stroke – from the pedal. The electric circuit ensures the operation of shears in single and automatic strokes.
The shears bed is fully welded, it consists of two side racks connected by a clamping beam and a traverse table. Welded seams that have undergone additional heat treatment provide structural rigidity and preservation of geometric dimensions during operation. On the table, with the help of screws, are installed: a movable bar of the lower knives, which allows to adjust the cut line and the gap between the knives, side stop, table extensions and ball bearings that facilitate the movement of the cut sheet. Hydraulic clamps are installed on the clamping beam, with polyurethane inserts, eliminating sheet sliding and the appearance of defects on thin metal.