Hydraulic guillotine НГ25Г.02 is designed for direct longitudinal and transverse cutting of sheet material. Metal cutting is performed in one stroke of the knife according to the marking or stop. Convenience in work, reduced levels of noise, high cutting quality and reliability of hydraulic guillotine shears, as well as various equipment options, allow to operate this equipment in industries with high demands on equipment quality. The shears work setting is controlled from the remote control, working stroke – from the pedal. The electric circuit ensures the operation of shears in single and automatic strokes.
– Control panel with a DRO (controller) on the bed;
– Foot pedal with a function to control the length of the cut;
– Worktable equipped with built-in ball bearings for easier movement of metal into the cutting zone;
– Working area lighting with a laser indicator of the cut line – for a more accurate cut of metal without the use of a back stop;
– Frontal extenders of the table with a side bar of 1000 mm;
– Standard rear motorized stop – button control from the remote control, position information is displayed on the DRO display;
– Electronic counter of moves, indications on the display of a DRO of the control panel;
– Hydraulic clamps with polyurethane inserts – they do not damage the metal;
– Adjustable angle of longitudinal inclination of the knife beam to eliminate the twisting effect of the cut-off workpiece – push-button control on the remote control;
– Adjustable clearance between the knives for a better cut of metal of various thicknesses – push-button control from a separate panel with the output of information on a special scale. A table with recommended clearances for various types of metal is located next to the scale, on the bed of scissors.