Hydraulic guillotine with a sheet width of 3150 mm НГ32Г.02 is designed for direct longitudinal and transverse cutting of sheet material. Metal cutting is performed in one stroke of the knife according to the marking or stop. Convenience of operation, reduced levels of noise, high quality of cutting and reliability of hydraulic guillotine, as well as various equipment options, allow to operate this machine in industries with high demands on the quality of equipment. The shears work setting is controlled from the remote control, working stroke – from the pedal. Electric circuit ensures the operation of shears in single and automatic strokes.
– Control panel with DRO (controller) on the bed;
– Foot pedal with cutting length control function;
– Worktable equipped with built-in ball bearings for easier movement of metal into the cutting zone;
– Working area lighting with a laser pointer of the cutting line – for more accurate cutting of metal without use of back stop;
– Front side support, if necessary, easy to clean;
– Standard rear motorized stop – button control from remote control, position information is displayed on DRO;
– Electronic counter of moves, indications on the display of DRO of the control panel;
– Hydraulic clamps with polyurethane inserts – they do not damage metal;
– Adjustable angle of longitudinal inclination of the knife beam to eliminate twisting effect of the cut workpiece – push-button control using remote control;
– Adjustable gap between knives for better cutting of metal of various thicknesses – push-button control from a separate panel with the output of information on a special scale. Table with recommended clearances for various types of metal is located next to the scale on the bed of scissors.